overview

Lenco Electric Trim Tab Kit (312558)

610 x 915mm Ram - Approx 300mm Stroke 

- Suits Most Engine Hatches - 12 Volt

Overview:

• Sizes available with 4" thru 30" stroke. Available in 12- and 24-vol
• Complete with 2' lead and Deutsch plug (actuator extension harnesses are available in lengths of  7', 14', 20', 26', 32' and 45')
• Clutchless ball screw design will not drift, never binds and runs in sync on dual lift applications
• Inline motor design delivers over 500 lbs. (226.79 Kg) of force
• Water Resistant, made entirely of non-corrosive materials
• Ball screw spins freely when hatch is fully opened or closed eliminating limit switches and burned out motors
• Mounting brackets with stainless steel pull pins
• Powdered metal gears for strength and  precision
• Stainless steel ram locks in any position
• Amp draw 10 amps at 12-volt and 5 amps at 24-volt
• CE Certified and ABYC compliant

Downloads:

• Lenco Electric Hatch Lift Product Brochure
• Lenco Electric Hatch Lift Rocker Switch (312528)

specification

Lenco Hatch Lift Installation/Operation

Due to the many different variables involved with the numerous applications for Lenco hatch lifts, installation is never the same. Here are some general guidelines that can be of assistance:

•  The actuator is most powerful when it is installed vertically at 90 degrees.

•  Lifting capabilities decrease (due to the fact that the force pounds increase) the closer the upper or lower mount is located to the hinge.

•  The further from a vertical position the less lifting capability. When retracted, Do Not position hatch lift at an angle less than 45 degrees.

•  Dual hatch lift systems are recommended for hatches over 500 pounds (226.79 kg) of force.

•  Lenco hatch lifts are designed around a ball screw that spins freely when hatch is fully open or closed.

•  The hatch lift must be allowed to free spin at both ends of its stroke or it will continue to push or pull against any resistance potentially damaging the hatch lift or the hatch itself.

•  Failure to make accurate measurements could cause damage to hatch lift or the hatch itself.

•  Lenco hatch lifts are waterproof and will not drift.

•  Lenco hatch lifts are offered in both 12 and 24 volts.

OPERATION:

The function of the Lenco Hatch Lift System is simple. Since the hatch lift is based around a ball screw it is able to push a heavy load and remain at a constant position. To raise a load, extend the hatch lift by pressing on the upper part of the switch. To lower a load, retract the hatch lift by pressing the lower part of the switch.

In case of power failure, Lenco hatch lifts are supplied with two clevis pins at the mounting brackets. To pull this pin out while the hatch is closed, you can: A) Rig a cable to pin and rig to a point outside of the hatch. B) Install an inspection plate where the pin will be accessible. C) Install Lenco's hatch lift slide bracket (Part # 70381-001). This will allow you to pull the hatch open 4" (10.16 cm) in order to reach and pull pin.